Transfer to nitrocellulose and alkaline phosphatase detection (OWL)
Western Blotting Protocol
This protocol is designed for transferring proteins using the OWL Transblot.
1. Chill transfer buffer at -20 ° C for at least one hour before use.
2. Soak gel, transfer pads, and Whatman 3MM paper in transfer buffer for 30-60 min at 4°C.
3. Assemble the following in the cassette starting on black side: pad, filter, gel, pre-wetted nitrocellulose (NC), filter, pad. Ensure there are no air bubbles.
4. Fill transfer assemble 3/4 full with transfer buffer. Insert transfer cassettes. Run at constant 150 mA for 1.25 h
5. Remove NC filter. Place in petri dish.. Add 10- 20 mL Blotto buffer. Shake 1 h at RT (Can be left O/N at 4°C).
6. Discard blotto. Wash once with 20 mL PBS-TWEEN.
7. Add 10 – 20 mL blotto and 10-20 µL of antiserum (1:1000 dilution; this is a good starting place but the dilution value must be determined empirically for each antiserum). Incubate 1 h at RT or O/N at 4°C.
8. Remove blotto and antiserum. Add sodium azide to 0.02%. Store diluted antiserum at 4°C.
9. Wash filter with 20 mL PBS-TWEEN for 15′. Repeat for total of 3 times
10. Add 10 mL blotto and 10 µL of goat anti-rabbit-AP (Fisher). Incubate 1h at RT.
11. Repeat #9.
12. Rinse with 1xPBS. Then soak in 10 mL 1x alkaline phosphatase buffer for 15′.
13. Immediately before (<30 min) color development mix:
14. Develop blot until desired intensity is achieved.
15. Stop in STOP buffer for 15 min. Then place in water O/N.
16. Air dry, keep out of bright light.
COLOR DEVELOPMENT:
Alkaline phosphatase buffer:
100 mM Tris-Cl pH 9.5
100 mM NaCl
5 mM MgCl2
Stop buffer:
10 mM Tris-Cl, pH 6.0
5 mM EDTA
NBT: (nitroblue tetrazolium)
50 mg/mL in 70% N:N,-dimethyl formamide
BCIP: (5-bromo-4-chloro-3-indolyl phosphate)
50 mg/mL in 100% formamide